Skip to main content

the curing lab · Series 2 · Field Note #013

The Most Valuable Empty Space in Your Plant

The gaps between parts may be your most valuable space. How part spacing and loading density shape thermal energy in the cure oven.

The Most Valuable Empty Space in Your Plant
From my field notebook

When I ask people where the most valuable space in their plant is, I usually get the same answers.

  • The powder booth.
  • The curing oven.
  • The shipping area.

Almost nobody points to the empty space between the parts.

Yet that space can have a tremendous influence on how thermal energy moves through the process.

One of the easiest assumptions to make in manufacturing is this:

“If every hook is full, we’re maximizing production.”

Sometimes that’s true. Sometimes it isn’t.

I’ve walked through plants where everyone was focused on filling every available space. But no one stopped to ask a different question.

“What happens to the thermal energy when we do?”

Every curing oven has a finite amount of thermal energy available at any given moment. How that energy reaches each part depends on much more than the temperature controller:

  • Part spacing.
  • Loading density.
  • Airflow.
  • Line-of-sight.
  • Thermal mass.

They all influence how thermal energy is distributed throughout the process.

Change the loading, and you’ve changed the process.

In a convection oven, closely loaded parts can alter airflow and reduce heat transfer to certain surfaces. In infrared systems, parts can create thermal shadows that reduce the radiant energy reaching nearby surfaces.

Different heat transfer mechanisms. Same engineering principle.

Loading influences energy distribution.

One lesson I’ve learned after walking hundreds of manufacturing plants is this:

It’s usually easier—and far less expensive—to change how the parts enter the oven than it is to change the oven itself.

I’ve seen manufacturers spend hundreds of thousands of dollars planning to make an oven bigger, only to discover that improving how thermal energy reached the parts solved the problem.

Sometimes increasing the space between parts improves how thermal energy reaches each one. That can lead to more consistent curing, fewer defects, and in some applications, enough process stability to support higher line speeds.

One empty hook doesn’t always reduce throughput. Sometimes it improves it.

Because experienced process engineers don’t just count parts. They think about good parts per hour.

Lab experiment

The next time you walk your curing line, forget the oven settings. Forget the conveyor speed.

Instead...

Watch the spaces between the parts.

Ask yourself:

"How is that space influencing the path of the thermal energy?"

Notebook Margin

Changing the load changes the energy path.

Plant floor challenge

This week, spend ten minutes watching your curing line. Don't watch the temperature controller, watch the spaces between the parts, and ask yourself:

  • Where is airflow restricted?
  • Where could radiant energy be blocked?
  • Where might changing the spacing improve how thermal energy is distributed?

If you discover something interesting, I'd love to hear what you found.